Tuesday, November 10, 2009


Speeding Up Your PPPoE Connection

If you use a Point-to-Point Protocol connection over Ethernet (PPPoE), you may notice a delay in using the PPPoE connection after startup.

By default, there is a 120 second delay but you can stop this behavior by manually configuring an IP address for the network adapter card.

If you do not use a PPPoE connection, you can skip this section.

1. Select Start/Connect to/Show All Connections.

2. Open the TCP/IP properties for your LAN network interface card.

3. Manually set the IP address on the TCP/IP properties to an appropriate IP address and subnet mask for your network


Post a Comment

my pleasure in helping you

Design by Free WordPress Themes | Bloggerized by Lasantha - Premium Blogger Themes | Aruz Parajuli, Aruz Parajuli